
Автор: William Irwin
Год издания: 0000
Savor moments of Zen like never before, with our Senior Philosophical Correspondents The Ultimate Daily Show and Philosophy is revised, expanded, and updated to probe deeper than ever before the philosophical significance of the quintessential “fake” news show of the 21st century. Features significant revisions and updates from the first 2007 edition Includes discussion of both The Daily Show and its spin-off, The Colbert Report Reveals why and how The Daily Show is philosophically engaging and significant Showcases philosophers at their best, discussing truth, knowledge, reality, and the American Way Faces head on tough and surprisingly funny questions about politics, religion, and power

Автор: Gracie Renzo, Gracie Royler, Danaher John
Год издания:
During the last decade, the martial arts world has looked to innovative mixed martial arts competitions such as the Ultimate Fighting Championship to determine which fighting style is the best. These contests have repeatedly shown the grappling style of martial arts, headed by Brazilian jiu-jitsu, to dominate. The Brazilian jiu-jitsu style stems from the premise, garnered from analysis of actual street fights, that the outcome of any fight is decided on the ground. While most martial arts deal only with the initial punching and kicking stages of combat, Brazilian jiu-jitsu concentrates on ground combat. This guide shows how to use Brazilian jiu-jitsu to increase combat effectiveness. Photographs and step-by-step instructions show how to master the techniques used in this exciting new form of combat.
Renzo Gracie, a two-time world Abu Dhabi submission jiu-jitsu champion, two-time Brazilian national champion, World Combat champion, and Martial Arts Reality Superfight champion, teaches Brazilian jiu-jitsu at an elite martial arts academy. Royler Gracie has competed in the Black Belt ranks for 20 years, winning the world title four times and the Abu Dhabi world submission championship for two consecutive years. They live in New York City.

Автор: Монолит
Год издания:
Содержание
Введение
Действия в чрезвычайных ситуациях
- Комплект инструментов
- Замена колеса
- Замена ламп
- Блок реле и предохранителей
- Буксировка автомобиля
- Прокачка системы питания
- Срабатывание контрольных ламп
- Техническая информация автомобиля
- Органы управления, приборная панель, оборудование салона
- Уход за кузовом и салоном автомобиля
- Техническое обслуживание автомобиля
- Базовый комплект необходимых инструментов
- Методы работы с измерительными приборами
- Двигатель в сборе
- Приводные ремни
- Головка блока цилиндров
- Ремонт двигателя
- Головка блока цилиндров
- Крышка головки блока цилиндров
- Сервисные данные и спецификация
- Двигатель в сборе
- Приводные ремни
- Сальники коленчатого вала
- Головка блока цилиндров
- Ремонт двигателя
- Сервисные данные и спецификация
- Двигатель в сборе
- Головка блока цилиндров
- Приводные ремни
- Маховик
- Ремонт двигателя
- Ремонт головки блока цилиндров
- Сервисные данные и спецификация
- Модификация с дизельным двигателем объемом 2,3 л (F1A)
- Модификация с дизельным двигателем объемом 3,0 л (F1C)
- Модификация с дизельным двигателем объемом 2,8 л (8140)
- Сервисные данные и спецификация
- Общие сведения
- Модификация с дизельным двигателем объемом 2,3 л (F1A)
- Модификация с дизельным двигателем объемом 3,0 л (F1C)
- Модификация с дизельным двигателем объемом 2,8 л (8140)
- Сервисные данные и спецификация
- Общие сведения
- Модификация с дизельным двигателем объемом 2,3 л (F1A)
- Модификация с дизельным двигателем объемом 3,0 л (F1C)
- Модификация с дизельным двигателем объемом 2,8 л (8140)
- Сервисные данные и спецификация
- Модификация с дизельным двигателем объемом 2,3 л (F1A)
- Модификация с дизельным двигателем объемом 3,0 л (F1C)
- Модификация с дизельным двигателем объемом 2,8 л (8140)
- Модификация с дизельным двигателем объемом 2,3 л (F1A)
- Модификация с дизельным двигателем объемом 3,0 л (F1С)
- Модификация с дизельным двигателем объемом 2,8 л (8140)
- Модификация с дизельным двигателем объемом 2,3 л (F1A)
- Модификация с дизельным двигателем объемом 3,0 л (F1С)
- Модификация с дизельным двигателем объемом 2,8 л (8140)
- Диск сцепления
- Упорный подшипник
- Гидропривод сцепления
- Панель педали сцепления
- Сервисные данные и спецификация
- Короба передач в сборе
- Коробка передач 5 S 200 – 5 S 270 – 5 S 300
- Коробка передач 6 S 300 1 3
- Коробка передач 6 S 380
- Сервисные данные и спецификация
- Карданный вал
- Задний мост
- Передний мост
- Сервисные данные и спецификация
- Передняя подвеска
- Задняя подвеска
- Задняя пневматическая подвеска
- Сервисные данные и спецификация
- Технические операции на автомобиле
- Передний тормозной механизм
- Задний тормозной механизм
- Стояночный тормоз
- Антиблокировочная система тормозов и система курсовой устойчивости
- Сервисные данные и спецификация
- Технические операции на автомобиле
- Верхний рулевой вал
- Нижний рулевой вал
- Рулевой механизм с гидравлическим усилителем
- Рулевая тяга
- Насос усилителя рулевого управления
- Сервисные данные и спецификация
- Общая информация
- Интерьер
- Экстерьер
- Сервисные данные и спецификация
- Общие сведения
- Электронный блок управления системой подушек безопасности
- Модуль подушки безопасности водителя
- Контактный диск
- Модуль подушки безопасности переднего пассажира
- Ремни безопасности с преднатяжителями
- Основные моменты методики утилизации модулей подушек безопасности и преднатяжителей
- Технические операции на автомобиле
- Блок отопителя / кондиционера воздуха в сборе
- Блок управления кондиционером воздуха
- Электронный регулятор кондиционера воздуха
- Антиобледенительный датчик
- Электрический вентилятор
- Радиатор отопителя
- Приводы заслонок системы кондиционирования воздуха
- Испаритель
- Компрессор кондиционера воздуха
- Фильтр салона
- Трехуровневый датчик давления и фильтр осушителя
- Конденсатор
- Отопитель типа «Marelli»
- Дополнительная система отопления и вентиляции пассажирского отсека
- Блок реле и предохранителей
- Комбинация приборов
- Система блокировки дверей с противоугонной сигнализацией
- Электросхемы

Автор: Монолит
Год издания:
Content
Introduction
Actions in emergency situations
- Toolkit
- Wheel replacement
- Replacing lamps
- Relay and fuse block
- Towing the car
- Prorolling the power system
- Triggering of warning lights
- Technical information of the car
- Controls, dashboard, salon equipment
- Caring for the body and salon of the car
- Vehicle maintenance
- Basic set of necessary tools
- Methods of working with measuring devices
- Engine assembly
- Drive belts
- Cylinder head
- Engine repair
- Cylinder head
- Cylinder head cover
- Service data and specification
- Engine assembly
- Drive belts
- Crankshaft seals
- Cylinder head
- Engine repair
- Service data and specification
- Engine assembly
- Cylinder head
- Drive belts
- Flywheel
- Engine repair
- Repairing the cylinder head
- Service data and specification
- Modification with a 2.3 l diesel engine (F1A)
- Modification with a 3.0 l diesel engine (F1C)
- Modification with a 2.8 l diesel engine (8140)
- Service data and specification
- Background
- Modification with a 2.3 l diesel engine (F1A)
- Modification with a 3.0 l diesel engine (F1C)
- Modification with a 2.8 l diesel engine (8140)
- Service data and specification
- Background
- Modification with a 2.3 l diesel engine (F1A)
- Modification with a 3.0 l diesel engine (F1C)
- Modification with a 2.8 l diesel engine (8140)
- Service data and specification
- Modification with a 2.3 l diesel engine (F1A)
- Modification with a 3.0 l diesel engine (F1C)
- Modification with a 2.8 l diesel engine (8140)
- Modification with a 2.3 l diesel engine (F1A)
- Modification with a 3.0 l diesel engine (F1С)
- Modification with a 2.8 l diesel engine (8140)
- Modification with a 2.3 l diesel engine (F1A)
- Modification with a 3.0 l diesel engine (F1С)
- Modification with a 2.8 l diesel engine (8140)
- Clutch disc
- Thrust bearing
- Clutch hydraulic drive
- Clutch pedal pad
- Service data and specification
- Gearbox assembly
- Transmission 5 S 200 - 5 S 270 - 5 S 300
- Gearbox 6 S 300 1 3
- Gearbox 6 S 380
- Service data and specification
- Propeller shaft
- Rear axle
- Front axle
- Service data and specification
- Front suspension
- Rear suspension
- Rear air suspension
- Service data and specification
- Technical operations on the car
- Front brake
- Rear brake
- Parking brake
- Antilock brake system and stability control
- Service data and specification
- Technical operations on the car
- Upper steering shaft
- lower steering shaft
- Steering gear with hydraulic booster
- Steering link
- Pump of power steering
- Service data and specification
- General information
- Interior
- Exterior
- Service data and specification
- Background
- Electronic airbag management system
- Driver airbag module
- Contact disk
- Front passenger airbag module
- Seat belts with retractors
- Highlights of the methodology for the disposal of airbag modules and pretensioners
- Technical operations on the car
- Heater / air conditioning unit assembly
- Air conditioning control unit
- Electronic air conditioner controller
- Anti-icing sensor
- Electric fan
- Heatsink radiator
- Drives of the air-conditioning flaps
- Evaporator
- Air conditioning compressor
- Cabin filter
- Three-level pressure sensor and desiccant filter
- Condenser
- Marelli-type heater
- Additional heating and ventilation system for the passenger compartment
- Relay and fuse block
- Instrument cluster
- Door locking system with anti-theft alarm
- Wiring diagrams

Автор: Николай Камзин
Год издания:
As part of the dynamics of international economic cooperation by the need for mutual settlement operations, so the problem of organization of settlements is an important place for the economically active subjects, especially in a globalized economic space in the functioning of transnational structures and scale of the export, import and international financial transactions. In agreeing on the order of calculations, the participants determined the form of payment in order to fulfill the financial obligations of the agreement – regulated by means of voluntary compliance through a credit institution liabilities, characterized by specific features on the order of transfer of funds to the account, a certain kind of settlement document, as well as office procedures. The source of payment relations is the need to have one contractor expressed in the appropriate disposition, the other in shortage. This relationship gives rise as a consequence of the relationship with the lending institution. Need to accession will intensify in the subjects of international payment relationship.

Автор: Н. В. Александрович
Год издания: