![]() |
This book provides only a description of the repair of the engine CWVA / CWVB / CZCA
To get acquainted and to buy the full book on car repair VW Polo since 2015 (including engine) it is possible under the link
Content
Engine
Reference data
Design description
Engine compartment - cleaning
Engine lubrication system - checking the oil level
Engine lubrication system - changing oil and oil filter
Engine - condition check
Checking by appearance
Checking compression in engine cylinders
Oil pressure test
Checking oil consumption
Engine mudguard - removal and installation
Removing the crankcase protection
Removing the engine mudguard
Accessory drive belt - check and replace
Checking the condition of the belt
Belt replacement
Timing belt - check and replace
Checking the condition of the timing belt
Replacing the timing belt
Powertrain mounts - Replacement
Replacing the right support
Replacing the left support
Replacing the rear support
Engine management
Reference data
Description of the system
Engine management sensors
Air intake system
Fuel system
Ignition system
Variable valve timing system
Emission control system
Safety precautions for maintenance and repair of the engine management system
Engine management system - troubleshooting
Troubleshooting
Deleting fault codes
Checking the power system
Checking and replacing sensors of the engine management system
Crankshaft position sensor - replacement
Camshaft position sensor - replacement
Absolute pressure and air temperature sensor in the intake manifold - replacement
Knock sensor - removal, inspection and replacement
Gas pedal position sensor - replacement
Coolant temperature sensor - replacement
Oxygen sensor - replacement
Brake pedal position sensor - removal and installation
Clutch pedal position sensor - removal and installation
Air filter - maintenance check, cleaning and replacement
Air filter - housing removal
Throttle assembly - removal and installation
Throttle Assembly - Cleaning
Ignition coil - removal and installation
Spark plugs - replacement
Power system - condition check
Diagnostics of the fuel supply system by external signs
Checking the fuel pressure in the fuel line
Cleaning the fuel system
Fuel injectors - replacement
Fuel filter - replacement
Valve for changing the valve timing - check and replace
Canister purge valve
Checking and replacing
Cooling system
Troubleshooting
The engine is overheating
Increase engine warm-up time
Permanent drop in coolant level
Pressure in the cooling system
Coolant
Checking the coolant level
Density test
Changing the coolant
Thermostat
Replacing thermostats
Exhaust system
Replacing the suspension cushions of the exhaust system
Replacing the optional muffler
Replacing the main muffler
Catalytic converter |