| Content
General
General description
Specifications
Construction and operation
Service standards
Engine
Adjustment standards
Service standards
Special tools
Inspection and adjustment of engine
Tightening torque table
Sealant, oil and grease
Removal and installation of auxiliaries
Measurement of compression pressure
Oil pressure
Inspection and adjustment of valve clearance
Bleeding of fuel system
Inspection and adjustment of fuel injection start timing
Inspection and adjustment of no-load minimum and maximum speeds
Inspection and adjustment of v-belt tension troubleshootin
Engine proper
Preparations
Removal and installation
Inlet and exhaust
Disassembly
Inspcetion and correction
Reassembly
Lubrication
Oil pump
Oil filter
Oil cooler
Relief valve
Regulator valve
Check valve
Cooling
Water pump
Thermostat
Radiator
Cleaning
Cooling system
Gas leakage test
Fuel
Injection pump general
Injection nozzle
Fuel filter
Water separator
Electrical
Starter
Starter relay
Alternator
Preheater
Other equipment
Air compressor
Injection pump drive
Automatic stop system
Over heat warning unit
Oil pressure switch |
Copyright (c) 2008 disc.allsave.info.