![]() |
This book provides only a description of the repair of the engine H4M / F4R
To get acquainted and to buy the full book on car repair Nissan Terrano since 2016 (including engine) it is possible under the link
Content
Engine
Reference data
Design description
Engine compartment - cleaning
Engine lubrication system - checking the oil level
Engine lubrication system - changing oil and oil filter
F4R 2.0 engine
Engine H4M 1.6
Engine crankcase protection - removal and installation
Engine - condition check
Checking by appearance
Checking with instruments
Checking oil consumption
Lubrication pressure - check
Oil pressure test
Compression in the engine cylinders - check
Accessory drive belt
Checking the condition of the belt
F4R engine drive belt replacement
H4M engine drive belt replacement
Timing belt
Powertrain mounts - replacement
Replacing the right support
Replacing the left support
Replacing the rear support
Engine management
Reference data
Description of the system
Air intake system
Fuel supply system
Ignition system
Automatic variable valve timing
Emission control system
Safety precautions for maintenance and repair of the engine management system
Engine management system - troubleshooting
Troubleshooting
Deleting fault codes
Checking and replacing sensors of the engine management system
Crankshaft position sensor - replacement
Camshaft position sensor - replacement
Manifold absolute pressure sensor - replacement
Intake air temperature sensor - replacement
Gas pedal position sensor - replacement
Coolant temperature sensor - replacement
Oxygen sensors - replacement
Knock sensor - replacement
Air filter - cleaning and replacement
Air filter - housing removal and installation
Throttle assembly - removal and installation
Phase change valve - check and replace
Ignition coils - check and replacement
Spark plugs - replacement
Fuel system - fuel pressure relief
Power system - condition check
Diagnostics of the fuel supply system by external signs
Checking the fuel pressure in the fuel line
Cleaning the fuel system
Intake manifold receiver - removal and installation
Cooling system
Reference data
Design description
Cooling system - troubleshooting
The engine is overheating
Increase engine warm-up time
Permanent drop in coolant level
Cooling system - maintenance check
Checking the coolant level
Checking the cooling system
Checking the density of the coolant
Cooling system - changing the coolant
Thermostat - check and replacement
Removing the thermostat
Thermostat test
Setting the thermostat
Coolant pump - replacement
F4R 2.0 engine
Engine H4M 1.6
Exhaust system
Reference data
Design description
Exhaust system - maintenance check
Exhaust system suspension cushions - replacement
Exhaust system elements - replacement |